Quick IRONGATOR engineer's vice with quick moving system

#tif#
721Q/6-US

Foaie de calcul tabelar

pdfQuick IRONGATOR engineer's vice with quick moving system - 721Q/6-US

Mai multe despre produs

Profile

Pressing forceLifetime warranty

Caracteristicile produsului

  • corpul din otel turnat
  • bacuri forjate din otel carbon, calite si revenite
  • carcasa vopsita,bacuri protejate anti-coroziune,celelalte parti zincate
  • glisirele uniPRO asigira miscarea exacta a partii mobile
  • menghina poate fi combinata cu un suport rotitor
  • sistem rapid de miscare
#title#
codWidthL maxLenghtDiameterHeightThicknessWidthHeightLenghtWidthGreutate
62513012512033617 - 629566441761329014500
62513115014040020 - 75117805321115410523500
* Imaginea produsului este simbolica.Toate dimensiunile sunt exprimate în mm,greutatea în grame.

Utilizare (Video)

Accesorii

Safety tips

check-mark-yes.png
  • Avoid clamping with heavy pressure on the corner of the vice jaws as it may break off a corner of a jaw.
  • Replace a bent handle as soon as possible.
  • Use bolts in all of the holes in the base of the vice.
  • Use lock washers under the nuts.
  • When work is held in a vice for sawing, saw as close to the jaws as possible to prevent vibrations. Be careful not to cut into the jaws.
  • When clamping extra long work, support the far end of work rather than putting extra pressure on the vice.
  • Regularly lightly oil all moving parts.
  • If the threaded part of the vice is exposed, keep it free of chips and dirt.
  • Discard any vice that exhibits the slightest hairline fracture.
  • Always use a vice large enough to hold the work without strain.
check-marks-no.png
  • Don't use the jaws of a vice as an anvil.
  • Never use an extension handle for extra clamping pressure.
  • Never pound on the handle to tighten beyond hand pressure.
  • Never try to repair a vice by welding or brazing.
  • Don't try to bend a heavy rod in a light vice.

  • Manevrabilitate

    Larga gama de scule este gandita pentru mai multe grupe tinta de utilizatori. Mecanismele de strangere asigura strangerea rapida si simpla. Discurile taietoare si abrazive sunt proiectate sa lucreze atat pe metale moi cat si pe metale tari, plastic, etc.

  • Prindere optima

    Sculele Unior se disting prin asigurarea unei strangeri ferme a obiectelor de lucru, fara raniri. Sinele dispozitivelor de strangere asigura miscarea precisa a falcilor prin miscarea rapida a manerului.

  • Materiale de cea mai inalta calitate

    Design-ul bine gandit si realizarea precisa previn defectiuni supra obiectului de lucru, chiar si sub incarcari considerabile. Cu aceste caracteristici, eficientel sculele Unior sunt alegerea potrivita pentru meseriasii care cer scule de calitate si durabile cu o durata de serviciu mai mare